Download  Print this page

Enabling Or Disabling The Erp Lps Compliance Mode; Enabling Or Disabling The Configuration Change Detection - Lenovo ThinkStation P510 Hardware Maintenance Manual

Hide thumbs

Advertisement

3. Select the feature you want to enable or disable and press Enter.
4. Select the desired setting and press Enter.
5. To save settings and exit the Setup Utility program, press F10, select Yes in the window displayed,
and press Enter.
Note: For some keyboards, you might need to press Fn+F10 to exit the Setup Utility program.

Enabling or disabling the ErP LPS compliance mode

Lenovo computers meet the eco-design requirements of the ErP Lot 3 regulation. For more information, go
to:
http://www.lenovo.com/ecodeclaration
You can enable the ErP LPS compliance mode in the Setup Utility program to reduce the consumption of
electricity when your computer is off or in sleep mode.
To enable or disable the ErP LPS compliance mode, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 65.
2. Select Power ➙ Enhanced Power Saving Mode and press Enter.
3. Select Enabled or Disabled depending on your needs, and then press Enter. If you select Enabled, you
also need to disable the Wake on LAN feature. See "Enabling or disabling the automatic power-on of
your computer" on page 65.
4. To save settings and exit the Setup Utility program, press F10, select Yes in the window displayed,
and press Enter.
Note: For some keyboards, you might need to press Fn+F10 to exit the Setup Utility program.
When the ErP LPS compliance mode is enabled, you can wake up your computer by doing one of the
following:
• Press the power button.
• Enable the Wake Up on Alarm feature to make your computer wake up at a set time. See "Enabling or
disabling the automatic power-on of your computer" on page 65.
• Enable the After Power Loss feature to make your computer wake up when the power supply resumes
after a sudden loss of electricity.
To enable the After Power Loss feature, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 65.
2. Select Power ➙ After Power Loss and press Enter.
3. Select Power On and press Enter.
4. To save settings and exit the Setup Utility program, press F10, select Yes in the window displayed,
and press Enter.
Note: For some keyboards, you might need to press Fn+F10 to exit the Setup Utility program.

Enabling or disabling the configuration change detection

When the configuration change detection is enabled, if the POST detects configuration changes of some
hardware devices (such as storage drives or memory modules), an error message is displayed.
To enable or disable the configuration change detection, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 65.
66
ThinkStation P510 and P710 Hardware Maintenance Manual

Advertisement

Table of Contents

   Related Manuals for Lenovo ThinkStation P510

Comments to this Manuals

Symbols: 0
Latest comments: