I.link Troubleshooting - Pioneer DV-668AV Operating Instructions Manual

09 Additional information
Problem
A connected HDMI
component doesn't work
with this player.

i.LINK troubleshooting

(DV-868AVi only)
Problem
No i.LINK audio output.
Auto Select Play doesn't
work.
i.LINK audio is temporarily
interrupted.
No multichannel i.LINK
audio.
94
En
Remedy
• Depending on the connected component, this player may not work
properly with it. See the operating instructions that came with the
other component.
Remedy
• If the front panel i.LINK indicator is lit then:
– Check that your AV receiver is DTCP (Digital Transmission Copy
Protection) compatible.
– Check that your AV receiver is compatible with the type of disc that
you're trying to play (for example, SACD).
• If the front panel i.LINK indicator is unlit then:
– Check that your AV receiver is set to the correct input.
– Check that the i.LINK cable is connected properly and that the cable
isn't damaged. Use an i.LINK cable no longer than 3.5 meters.
– Check that components connected using the i.LINK interface are
switched on and i.LINK Audio compatible. Do not connect DV format
players/recorders or personal computers.
– Check that the i.LINK Audio Out setting is On (see Audio Out on
page 76).
PURE AUDIO
– Check that the
PURE AUDIO
button (
• Make sure that the receiver has been selected in the
Play
on page 77.
• Make sure that i.LINK Audio Out is set to On (see
page 76).
• Auto Select Play doesn't work while LINK CHECK shows in the front
panel display (see i.LINK-related messages opposite).
• See i.LINK-related messages for possible causes of this.
• For multichannel SACD playback, make sure that SACD Playback is
set to Multi-ch Area (see
• For multichannel DVD-Audio playback, make sure that Audio
Output Mode is set to 5.1 Channel (see
page 73).
indicator is not lit. If it is, press the
See also Front panel
on page 24).
SACD Playback on page 71).
Audio Output Mode
Auto Select
Audio Out
on
on