Troubleshooting; General - Pioneer DV-668AV Operating Instructions Manual

Additional information

Troubleshooting

• Incorrect operation is often mistaken for trouble or malfunction. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may
lie in another component. Inspect the other components and electrical appliances being
used. If the trouble cannot be rectified after checking the items below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.

General

Problem
The disc won't play or is
automatically ejected after
loading.
The player switches off
automatically when it's not
in use.
DVD-Audio playback stops. • The disc may have been illegally copied.
Picture playback stops and
the operation buttons
cannot be used.
New settings made in the
Setup screen menus while
a disc is playing are
ineffective.
Settings are canceled.
Remedy
• Make sure the disc is free from dirt and dust and is not damaged
(see Taking care of your player and discs on page 79).
• Make sure the disc is loaded with the label side face-up and aligned
properly in the disc tray guide.
• Incompatible region number: If the region number on a DVD-Video
disc does not match the number on the player, the disc cannot be
used (see DVD-Video regions on page 11).
• Condensation inside the player: Allow time for condensation to
evaporate. Avoid using the player near an air-conditioning unit.
DV-668AV only –
• This is not a malfunction.
inactive for 30 minutes with the disc tray closed (and no buttons
are pressed), the system automatically switches to standby
(except when a powered subwoofer is connected).
• Press , then start playback again ( ).
• Switch the power off once, unplug from the wall socket, then plug
back in and switch on again by
STANDBY/ON on the remote to switch the player on.
then
• Some settings can be changed while a disc is playing, but are not
effective until the disc is stopped then restarted: Press
playback again ( ).
• When the power is cut due to power failure or by unplugging the
power cord during operation, settings will be canceled. See Moving
the player on page 80 for proper shutdown instructions.
If the player is left
pressing POWER (DV-868AVi only)
09
, then start
89
En