I.link-Related Messages - Pioneer DV-668AV Operating Instructions Manual

Additional information
Problem
Playback starts
automatically when the
input function of the AV
receiver is changed to this
player.
A connected i.LINK
component doesn't work
with this player.

i.LINK-related messages

(DV-868AVi only)
You may see the following messages
displayed in the front panel display when
using the i.LINK interface.
LINK CHECK
The player is checking the i.LINK network. It
does this, for example, when components are
added or removed from the network. The
sound may be interrupted if this happens
during playback.
PQLS ON
Displayed when the player receives a rate
control on request from the receiver during
playback. The sound may be interrupted
momentarily when this happens.
Note that the PQLS feature works only when
the player is connected to a single receiver.
PQLS OFF
Displayed when the player receives a rate
control off request from the receiver during
playback. The sound may be interrupted
momentarily when this happens.
LOOP CONNECT
The i.LINK network cannot function because
it is connected in a loop (see Creating an
i.LINK network on page 20).
Remedy
• This is an i.LINK feature and not a malfunction.
• Depending on the connected component, this player may not work
properly with it. See also the operating instructions that came with the
other component.
BUS FULL
The i.LINK bus has reached its capacity and
cannot transmit any more data.
• Static electricity or other external
influences may cause malfunctioning of
this unit. In this case, unplug the power
cord and then plug back in. This will
usually reset the unit for proper operation.
If this does not correct the problem,
please consult your nearest Pioneer
service center.
09
95
En