Frequency Range; Warranty Notification; Regulatory Compliance Statements (Eu/Efta Only); Regulatory Compliance Statements (Usa And Canada Only) - ASCOM d81 User Manual

User Manual
Ascom d81 DECT Handset
2.1.1

Frequency Range

The handset is a radio transmitter and receiver. When it is on, it receives and sends out
radio frequency (RF) energy. The handset operates on different frequency ranges
depending on market and employs commonly used modulation techniques:
EU
USA
LA:
BR:
--:
2.1.2

Warranty Notification

Do not disassemble the handset. Disassembling the handset voids the warranty. The
handset consists of no consumer serviceable components. Service should be performed by
Authorized Service centre only.
2.2

Regulatory Compliance Statements (EU/EFTA only)

This equipment is intended to be used in the whole EU & EFTA.
This equipment is in compliance with the essential requirements and other relevant
provisions of R&TTE Directive 1999/5/EC. The Declaration of Conformity may be consulted
at:
https://www.ascom-ws.com/doc/
The handset is marked with the label
2.3

Regulatory Compliance Statements (USA and Canada only)

FCC ID: BXZDH5BL
IC: 3724B-DH5BL
US: 9FVW4NANDH5
FCC compliance statements
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
26 April 2010/ Ver. B
1880-1900 MHz
1920-1930 MHz
1910-1930 MHz
1910-1920 MHz
1900-1920 MHz
TD 92644GB
6