Secondary Connection - Besides PPPoE, if you use an extra connection type to connect to
a local area network provided by ISP, then parameters of this secondary connection will be
shown in this area.
IP Address - The current WAN (Internet) IP Address. This field will be blank or 0.0.0.0 if the
•
IP Address is assigned dynamically and there is no connection to the Internet.
Subnet Mask - The subnet mask associated with the WAN IP Address.
•
Click the Release to delete the network parameters, and click the Renew button to obtaining
network parameters.
Traffic Statistics - The Router's traffic statistics.
Received (Bytes) - Traffic that counted in bytes has been received out from the WAN port.
•
Received (Packets) - Traffic that counted in packets has been received out from the WAN
•
port.
Sent (Bytes) - Traffic that counted in bytes has been sent out from the WAN port.
•
Sent (Packets) - Traffic that counted in packets has been sent out from the WAN port.
•
System Up Time - The length of the time since the Router was last powered on or reset.
Click the Refresh button to get the latest status and settings of the Router.
8.3 Network
There are three submenus under the Network menu: WAN, MAC Clone and LAN. Click any of
them, and you will be able to configure the corresponding function.
8.3.1 WAN
Choose menu "Network → WAN", and then you can configure the IP parameters of the WAN on
the screen below.
1.
If your ISP provides the DHCP service, please choose Dynamic IP type, and the Router will
automatically get IP parameters from your ISP. You can see the page below:
TL-WR902AC
AC750 Wireless Travel Router
- 174 -