Pro-Form CROSSWALK 590 LT User Manual page 8

3. Remove the M10 Locknut (36), the M10 x 50mm
Bolt (26), and the shipping bracket (C) from the
Base (99). Attach a Wheel (95) with the Bolt
and the Locknut that you just removed. Do not
overtighten the Locknut; the Wheel must turn
freely. Discard the shipping bracket.
4. Identify the Right Upright (80) and the Right
Upright Spacer (90), which are marked with
"Right" stickers.
Insert the Wire Harness (92) through the Right
Upright Spacer (90) as shown. Then, set the
Right Upright Spacer on the Base (99). Be care-
ful not to pinch the Wire Harness.
Have a second person hold the Right Upright
(80) near the Base (99). See the inset draw-
ing. Tie the wire tie in the Right Upright securely
around the end of the Wire Harness (92). Then,
pull the other end of the wire tie until the Wire
Harness is routed through the Right Upright.
5. Hold a Screw Spacer (98) inside the lower end
of the Right Upright (80). Insert an M10 x 96mm
Screw (7) with an M10 Star Washer (8) into the
Right Upright and the Screw Spacer. Repeat
this step with a second Screw Spacer (98),
M10 x 96mm Screw (7), and M10 Star Washer
(8).
Hold the Right Upright (80) against the Right
Upright Spacer (90). Be careful not to pinch
the Wire Harness (92). Tighten the M10 x
96mm Screws (7) until the heads of the Screws
touch the Right Upright; do not fully tighten the
Screws yet.
3
26
95
C
36
4
92
80
Wire
92
Tie
5
80
8
99
Wire
Tie
80
92
99
7
8
92
90
90
98