Pro-Form CROSSWALK 590 LT User Manual page 12

13. Partially tighten two M8 x 25mm Bolts (4) with
two M8 Star Washers (9) into the Left Upright
(79) and the Left Handrail (21); do not fully
tighten the Bolts yet.
Next, partially tighten two M8 x 25mm Bolts (4)
with two M8 Star Washers (9) into the Right
Upright (80) and the Right Handrail (100). Then,
tighten all four Bolts.
See steps 5 and 8. Tighten the M10 x 96mm
Screws (7).
14. Remove the Resistance Knob (88) from a resis-
tance mechanism. Make sure that the 3/8" x
4 3/4" Screw (3) stays inside the resistance
mechanism and that the resistance mecha-
nism does not come apart. Note: See the
lower drawing to reassemble the resistance
mechanism if necessary.
Apply a small amount of the included grease
around the Resistance Cone (85). Insert the
Resistance Cone into the Upright Insert (84) in
the Left Upright (79), with the two large holes
on top as shown. Then, tighten the Resistance
Knob (88) onto the 3/8" x 4 3/4" Screw (3). Do
not fully tighten the Resistance Knob.
Attach the other resistance mechanism to
the Right Upright (80) as described above.
13
21
9 9
4
79
14
79
88
Grease
88
85
12
Console
Assembly
4
100
9
4
Large
Holes
84
85
Resistance
Mechanism
3
Large
Holes
3
4
9
80
80