Pro-Form CROSSWALK 590 LT User Manual page 13

15. Insert the end of a Crosswalk Arm (82) into the
hole in the top of a resistance mechanism. Make
sure that the bend in the Crosswalk Arm is
positioned as shown.
Tighten an M4.2 x 19mm Screw (1) into the
resistance mechanism and Crosswalk Arm (82)
from the direction shown. Press a Small Cap
(13) into the hole for the Screw.
Attach the other Crosswalk Arm (82) as
described above.
16. Raise the Frame (57) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (54) so that the large
barrel and the Latch Knob (55) are in the posi-
tions shown.
Attach the lower end of the Storage Latch (54) to
the Base (99) with a 3/8" x 1 3/4" Bolt (6).
Attach the upper end of the Storage Latch (54)
to the Frame (57) with a 3/8" x 1 3/4" Bolt (6)
and a 3/8" Jam Nut (5).
Lower the Frame (57) (see HOW TO LOWER
THE TREADMILL FOR USE on page 20).
17. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see
pages 22 and 23).
15
82
Hole
Resistance
Mechanism
16
57
5
55
Large
Barrel
99
13
Bend
13
1
82
1
13
6
54
6