Pro-Form CROSSWALK 590 LT User Manual page 10

8. Hold a Screw Spacer (98) inside the lower end
of the Left Upright (79). Insert an M10 x 96mm
Screw (7) with an M10 Star Washer (8) into the
Left Upright and the Screw Spacer. Repeat this
step with a second Screw Spacer (98), M10 x
96mm Screw (7), and M10 Star Washer (8).
Orient the Left Upright Spacer (89) and the Left
Upright (79) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(99). Tighten the M10 x 96mm Screws (7) until the
heads of the Screws touch the Left Upright; do
not fully tighten the Screws yet.
9. Press a Base Cap (91) into the Base (99).
With the help of a second person, tip the treadmill
so that the Base (99) is flat on the floor.
10. Set the console assembly face down on a soft
surface to avoid scratching the console assembly.
Identify the Right Handrail (100), which is
marked with a sticker. Hold the Right Handrail
near the console assembly. Attach the console
ground wire to the Right Handrail with a #8 x 1/2"
Ground Screw (29).
Next, insert the console wire into the large hole
in the Right Handrail (100) and pull it out of the
top as shown. Attach the Right Handrail with
three M4.2 x 19mm Screws (1). Make sure that
no wires are pinched. Start all three Screws
before tightening any of them; do not over-
tighten the Screws.
Remove the ties from the two M8 Cage Nuts
(39). If necessary, press the Cage Nuts back into
place.
8
7
8
98
89
99
9
91
99
10
100
39
Console
Ground Wire
Console
Assembly
10
79
Console
1
Wire
1
Large Hole
29
1