Pro-Form CROSSWALK 590 LT User Manual page 11

11. Attach the Left Handrail (21) to the console
assembly with three M4.2 x 19mm Screws (1).
Remove the ties from the two M8 Cage Nuts
(39). If necessary, press the Cage Nuts back into
place.
12. Have a second person hold the console assembly
near the Right Upright (80).
Connect the Wire Harness (92) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED
ON. Remove the wire tie from the Wire Harness.
Then, insert the connectors into the Right
Upright (80).
Set the console assembly on the Right Upright
(80) and the Left Upright (not shown). Make sure
that no wires are pinched.
11
21
39
Console
Assembly
12
92
Console Wire
Wire Tie
80
11
1
1
Console Assembly
Console
Wire
92