Configuration Examples - Edge-Core ES4624-SFP Routing Management Manual

only shows those with high priority.

1.3.5 Configuration Examples

The figure shown below is a simple network consisting of three layer3 switches, the network
mask for all switches and PC is 255.255.255.0. PC-A and PC-C are connected via the static
route set in SwtichA and SwitchC; PC3 and PC-B are connected via the static route set in
SwtichC to SwitchB; PC-B and PC-C is connected via the default route set in SwitchB.
PC-C:10.1.5.2
PC-A:10.1.1.2 PC-B:10.1.4.2
SwitchC vlan3:10.1.5.1
vlan1:10.1.3.2
vlan2:10.1.2.2
vlan1:10.1.1.1 vlan2:10.1.4.1
SwitchA
vlan2:10.1..2.1 vlan1:10.1.3.1 SwitchB
Fig 1-2 Static Route Configurations
Configuration steps:
Configuration of layer3 SwitchA
Switch#config
Switch (config) #ip route 10.1.5.0 255.255.255.0 10.1.2.2
Configuration of layer3 SwitchC
Switch#config
Next hop use the partner IP address
Switch(config)#ip route 10.1.1.0 255.255.255.0 10.1.2.1
Next hop use the partner IP address
Switch(config)#ip route 10.1.4.0 255.255.255.0 10.1.3.1
Configuration of layer3 SwitchB
Switch#config
Switch(config)#ip route 0.0.0.0 0.0.0.0 10.1.3.2
In this way, ping connectivity can be established between PC-A and PC-C, and PC-B and PC-C
32