Command For Bgp4 - Edge-Core ES4624-SFP Routing Management Manual

Command
Admin mode
debug ipv6 bgp
message send
no debug ipv6 bgp redistribute
message send
debug ipv6 bgp redistribute route
receive
no debug ipv6 bgp redistribute
route receive

1.9.3 Command For BGP4+

1.9.3.1 redistribute ospf
Command: redistribute ospf [<process-tag>] [route-map<word>]
no redistribute ospf [<process-tag>]
Function: To redistribute routing information form OSPFv3 to BGP4+. The no form of this
command will remove the configuration.
Parameters: process-id is the process id of the OSPFv3 process, limited between 1 and 65535.
If no process id is specified, the default process id will be used.
route-map <word> is the pointer to the introduced routing map.
Default: Not redistributed by default.
Command Mode: BGP IPv6 configuration mode.
Usage Guide: None.
Example: To redistribute routing information from OSPFv3 process with the tag as abc to
BGP4+ with the AS number as 1.
Switch(config)#router bgp 1
Switch(config-router)#address-family ipv6 unicast
Switch(config-router-af)#redistribute ospf abc
1.9.3.2 show ipv6 bgp redistribute
Command: show ipv6 bgp redistribute
Function: Show the configuration information of redistribution other out routing to bgp4+.
Parameter: None.
Default: Not shown by default.
Command Mode: Admin Mode and Configuration Mode.
Usage Guide: None.
Notes
redistribute
To enable or disable debugging messages
sent by BGP4+ for redistribution of OSPFv3
routing.
To enable or disable debugging messages
received from NSM.
243