Commands For Rip - Edge-Core ES4624-SFP Routing Management Manual

(3) To display ipv4 aggregation route information
Command
Admin Mode and Configuration Mode
show ip rip aggregate
6. Redistribution of OSPF Routing to RIP
(1) To enable Introduction of OSPF Routing for RIP
Command
Router rip configuration mode
redistribute ospf
[metric<value>] [route-map<word>]
no redistribute ospf [<process-id>]
（2）To display the redistribution configuration information
Command
Admin mode and configuration mode
show ip rip redistribute
（3）Debugging
Command
Admin mode
debug rip redistribute message send
no debug rip redistribute message
send
debug rip redistribute route receive
no debug rip redistribute route receive

1.4.3 Commands for RIP

1.4.3.1 accept-lifetime
Command: accept-lifetime <start-time> {<end-time>| duration<seconds>| infinite}
no accept-lifetime
Function: Use this command to specify a key accept on the key chain as a valid time period.
The "no accept-lifetime" command deletes this configuration.
Explanation
To display aggregation route information.
Notes
[<process-id>]
To enable or disable the redistribution of
OSPFv2 routing to RIP.
Notes
To display RIP routing introduced from other
routing protocols.
Notes
To enable or disable debugging messages
sent by RIP for redistribution of OSPFv2
routing.
To enable or disable debugging messages
received from NSM.
41