Maintenance; Safety; Maintenance Work; Machine Cleaning - Cramer TOURNO de Luxe 95 Operation Manual

7

Maintenance

7.1

Safety

DANGER !
Risk of injury by inappropriately
performed maintenance work!
Defective work may result in serious bodily injuries and
damage to property.
Make sure that you have sufficient working space.
Disconnect spark plug connectors when working on
the machine
Place components separately.
Remount all components.
Remount all safety covers.
Keep the risk area clear of persons.
ATTENTION!
Risk of injuries by combustion motors
Cleaning and repair work must never be carried out during
operation or when the machine runs idle, since this may
result in burns and cuts.
Stop machine and motor and let them cool down.
7.3

Maintenance work

Maintenance
Cleaning

Check safety precautions

Check all screws for tight fitting
Check motor oil level
Check air filter
Clean or replace air filter (normal use)
Clean or replace air filter (dusty conditions)
Adjust tyre pressure
Check machine for damage or corrosion on paint
coating and remedy as appropriate
Grease rotating points and joints
Check machine for fuel or oil leaks
Replace fuel filter
Replace spark plugs
X = Described in this Operation Manual in the indicated section.
O = Not described in the present Operation Manual
B = Description is enclosed in attached motor operation instructions.
TOURNO 696.01-01
Original Operation Manual English
7.2 Maintenance work
7.2.1

Machine cleaning

The machine should be cleaned regularly so that damage to
the paint coating or plastic components can be detected.
Please observe the notes listed for cleaning in order to avoid
damage to the electronics.
1. Park machine on an even surface before cleaning it and
activate the parking brake.
2. Clean the machine with a soft brush.
3. Subsequently clean the machine with a damp cloth.
NOTE !
Machine damage!
Do not clean the machine with spray water.
7.2.2 Check safety precautions
Safety precautions comprise:
- Cover of blades and V-belts
- Covers of drive wheels
- Motor cover
The machine must not be operated if the covers show any
signs of damage or are removed. They are to be replaced in
case of damage or loss. The machine must not be started
without safety precautions.
Prior to each use Annually
X (Item 7.2.1)
X (Item 7.2.2)
O
B
B
O
O
O
O
19 of 26
Intervals in hours
25 50 100
B
B
B
B
AS OF 2014
200