Empty The Grass Catcher; Operate On Slopes; Operation Tips; Maintenance - Cramer 82LM61SX Manual

EN
4. Adjust the speed control button with your left hand.
• Push the speed control button upward to increase the
speed.
• Push the speed control button downward to decrease
the speed.
5. Release the self-propel lever to stop the self-propel
system.
4.4

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge flap and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
6. Close the rear discharge flap.
7. Empty the grass catcher.
4.5

OPERATE ON SLOPES

Do not mow on the slopes with incline more than 15°. If
you are not comfortable, do not mow on a slope.
Please keep a low self-propelled speed when you mow on a
slope.
• Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
• Monitor the holes, ruts, rocks, and other hidden objects
that can cause you to fall. Remove all obstacles such as
rocks and tree limbs.
• Make sure that your footing is stable. If you are out of
balance, release the start handle immediately.
• Do not mow near drop-offs, ditches, or embankments.
4.6

OPERATION TIPS

• Do not try to override the operation of the start button or
bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
English (Original Instructions)
WARNING
WARNING
5

MAINTENANCE

WARNING
Remove the safety key and battery pack from the machine
before maintenance.
WARNING
Keep the engine and battery pack free from grass, leaves or
too much grease.
CAUTION
Use only approved replacement parts.
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
5.1

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use water.
5.2

REPLACE THE BLADE

Figure 10 & 11.
WARNING
Use only approved replacement blades.
WARNING
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting nut and spacer with a wrench or
socket.
7. Remove the blade.
8. Install the new blade. Make sure that the raised points
engage the hole(s) in the blade.
6