2.6-1 Turbo LED
The Turbo LED are always ON. You can connect the Turbo LED from the
system case to this pin. (See Figure 2.1)
2.6-2 Hardware Reset
Reset switch are use to reboot the system rather than turning the power ON/
OFF, but avoid rebooting will the HDD LED is lit. You can connect the Reset
switch form the system case to this pin. (See Figure 2.1)
2.6-3 Keylock
Keylock allows you to disabled the keyboard for security purposes. You
can connect the keylock to this pin. (See Figure 2.1)
2.6-4 Power LED
The Power LED is always lit while the system power is on. You can connect
the Power LED form the system case to this pin. (See Figure 2.1)
2.6-5 Suspend Switch
The Suspend Switch can be set in the BIOS Power Management Setup.
When used as a Suspend Switch, this allows the user to suspend the
system when not in use. (See Figure 2.1)
2.6-6 Speaker
Speaker from the system case are connected to this pin. (See Figure 2.1)
2.6-7 HDD LED
HDD LED shows the activity of a hard disk drive. Avoid tuning the power
off while the HDD led is lit. You can connect the HDD LED from the system
case to this pin. (See Figure 2.1).
2-19