GCC Technologies P3-60 User Manual page 52

Offline For
System Setup
[TOOL SELECT ]
[ MISC ]
The Control Panel
1S:51 F:80 O:0.275 M
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
Panel Setup
Select: OK:ENTER
Restore default
Select: OK:ENTER
Save parameter
Select: OK:ENTER
Auto Unrolled Media
Select: OK:ENTER
Vacuum
Select: OK:ENTER
First back to origin
Select: OK:ENTER
AAS Offset
Select: OK:ENTER
Paper Saving Mode
Select: OK:ENTER
Set Communication
Select: OK:ENTER
Firmware： x.x.xx
FPGA：Vx.x mm/dd/yy
Select Language
Select: OK:ENTER
Select Unit
Select: OK:ENTER
Image Scale Length
Select: OK:ENTER
Image Scale Width
Select: OK:ENTER
OverCut:0.00-1.00mm with an
increment of 0.05mm
Rear Paper Sensor
Select: OK:ENTER
Enable, Disable
Both Expanded Mode、Length Expanded Mode、
Width Expanded Mode、Both Unexpanded Mode
English, Chinese
Metric (cm/gram) or English measurement (inch/oz)
or Unit (cm/oz) or Unit (inch/gram)
Scale Length
Select: OK:ENTER
Scale Width
Select: OK:ENTER
3-4
Puma III User Manual
Enable, Disable