Specifications - SureCall Fusion2Go 2.0 User Manual

Specifications

Product
Uplink Frequency Range (MHz):
Downlink Frequency Range (MHz):
Input / Output Impedance:
Maximum Gain:
Noise Figure:
VWSR:
Gain Adjustment:
Supported Standards:
DC Power:
Maximum Output Power:
Cable:
RF Connectors:
Power Consumption:
Operation Temperature:
Dimensions:
Weight:
FCC / IC ID:
RF Exposure Warning:
The inside patch antenna must be installed so as to provide a separation distance of al least 20 cm (8 inches) from all persons
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present,
the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band
users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | Support@surecall.com
Fusion2Go 2.0 US
698-716 / 776-787 / 824-849 / 1850-1915 / 1710-1755 (G Block Included)
728-746 / 746-757 / 869-894 / 1930-1995 / 2110-2155 (G Block Included)
50 Ω
50 dB
≤ 5 dB
≤ 2.0
20 dB (Automatic)
CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO, LTE and all cellular standards
6-15V
1 Watt EIRP
SC-174
FME Male (both ends)
≤ 10W
-4º to +158º F
5.625 x 4 x 1.125 inches
1.43 lbs
RSN2GOMINI
Specifications
Fusion2Go 2.0 Canada
47.8 dB
3 Watt EIRP
7784A-2GOMINI
9