Step 1: Mount Outside Antenna; Step 2. Install The Inside Patch Antenna - SureCall Fusion2Go 2.0 User Manual

Vehicle voice and 4g data signal booster

Hide thumbs Also See for Fusion2Go 2.0:

Table of Contents

Installation

Step 1: Mount Outside Antenna

Place the magnetic-mount antenna on the top of your vehicle preferably toward the back, maximiz-

ing the distance from planned location of the inside patch antenna. Ensure that the antenna has at

least a 12-inch radius clear of obstructions and other radiating elements, such as a radio antenna.

Next, run the cable from the outside antenna to the inside of the vehicle near the planned location

of the booster (under the seat of the vehicle, or in the front or middle console ). Run the outside

antenna cord across the car's roof and under the front door insulation lining to hide and protect the

antenna cable.

Note: The outside antenna must not be collocated or operating with any other antenna or booster.

Find a location for the inside patch antenna that is within 2-3 feet of the typical cell phone location.

Choose a location that is at least 4 inches (10cm) away from metal and affix the antenna to the

chosen surface. Then run the connected cable to the planned location of the booster.

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | Support@surecall.com

Table of Contents

Do you have a question about the Fusion2Go 2.0 and is the answer not in the manual?