Clamp Removal; Clamp Installation - Graco LineLazer 3400 Operation - Repair - Parts

Clamp Removal

1. Remove engine. See Engine Removal, page 30.
2. Drain gasoline from tank according to Honda man-
ual.
3. Tip engine on side so gas tank is down and air
cleaner is up.
4. Loosen two screws (36) on clamp (38),
5. Push screwdriver into slot in clamp (38) and remove
clamp.
3A4587B Operation, Repair, Parts

Clamp Installation

1. Install engine shaft key (37)
2. Tap clamp (38) onto engine shaft (A). Maintain
dimension shown note 2. Chamfer must face
engine.
3. Check dimension: Place rigid, straight steel bar (B)
across face of clutch housing (45). Use accurate mea-
suring device to measure distance between bar and
face of clamp. Adjust clamp as necessary. Torque two
screws (36) to 125 ±10 in-lb (14 ±1.1 N·m).
37
ti6199a
Face of clutch housing
1
1.550 ±.010 in. (39.37±.25 mm)
2
Torque to 125 ±.10 in-lb (14 ±1.1 N·m)
3 3 3
Chamfer this side
4 4 4
Pinion Assembly/Clutch Armature/Clamp
45
1
B
36
A
ti5988a
2
37
4
3
29