Clutch Housing; Removal; Installation; Engine - Graco LineLazer 3400 Operation - Repair - Parts

Clutch Housing

Clutch Housing

Removal

1. Remove clamp. Do Clamp Removal, page 29.
2. Remove four screws (51) and lock washers (50)
which hold clutch housing (45) to engine.
3. Remove screw (145) from under mounting plate.
4. Pull off clutch housing (45).

Installation

1. Push on clutch housing (45).
2. Install four capscrews (51) and lock washers (56)
and secure clutch housing (45) to engine. Torque to
200 in-lb (22.6 N·m).
3. Install screw (145) from beneath mounting plate.
Torque to 26 ft-lb (35.2 N·m).

Engine

Removal
NOTE: All service to the engine must be performed by
an authorized HONDA dealer.
1. Remove Pinion Assembly/Clutch Arma-
ture/Clamp and Clutch Housing, as instructed on
pages 27, 29 and 30.
2. Disconnect all necessary wiring.
3. Remove two locknuts (111) and screws (110) from
base of engine.
4. Lift engine carefully and place on work bench.
pink
(from engine)
ground
green/yellow
30
51
clutch wires
Installation
1. Lift engine carefully and place on cart.
2. Install two screws (110) in base of engine and
secure with locknuts (111). Torque to 20 ft-lb (27.12
N·m).
3. Connect all necessary wiring.
4. Install Pinion Assembly/Clutch Armature/Clamp
and Clutch Housing, as instructed on pages 28, 29
and 30.
ti6390a
45
50
145
3A4587B Operation, Repair, Parts
ti6322a
110
ti6323a
111