Telemetry function (FASSTest mode only)
To use the telemetry function, set "Telemetry"
to "ACT".
DL Interval (FASSTest mode only)
When a telemetry function is enabled, the
receiving interval (down-link interval) of sensor
data can be changed.
If a DL interval is increased, the response of
the sensor data display becomes slower, but stick
response will improve.
System Type selection procedure
*An example of selections for each system is on the
following page.
Dual receiver function (only FASSTest 14CH
mode) procedure
74
<Functions of Linkage Menu>
Area mode selection (Frequency range)
procedure
*"F" is chosen only when using the transmitter is used in
France. Leave this in "G" otherwise.
Telemetry ACT/INH procedure
DL Interval set procedure