Dmx Pcb Assembly Replacement - Philips VL3015LT Service Manual

DMX PCB Assembly Replacement

VL Part No: 24.9664.4895
To remove and replace DMX PCB assembly:
Step 1. Remove power from luminaire.
WARNING: You must remove all power from luminaire before performing maintenance. Fixture
may be very HOT after operation. Allow it to cool completely before performing any maintenance.
Step 2. Remove LVS following instructions in
Step 3. At DMX PCB assembly, disconnect wiring from PCB.
Step 4. At front panel, remove four 4-40 x 3/8" PFB screws
Step 5. Remove PCB to inside of enclosure.
Note: When installing, always ensure the release for the female XLR is on the outside of the panel and
moves freely when pushed.
Step 6. Replace by performing steps in reverse order.
NOTE:
Some components not shown for clarity.
02.96 98.001 0 0
M P
AINTENANCE ROCEDURES
Display Panel
Assembly
Display
Cover
LVS Power Supply
Figure 2-27: DMX PCB Assembly Replacement
: DMX PCB A
SSEMBLY
"Power Supply (LVS) Replacement" on page
DMX PCB
Assembly
2
R
EPLACEMENT
48.
Display Panel Assembly
Screws
NOTE:
Drawing exploded for clarity.
51