Philips VL3015LT Service Manual page 134

❋
VARI LITE - VL3015LT S
Tilt Motor Assembly (continued)
5
See Detail A
14 (x2)
6
9 (x4)
8 (x2)
2
11 (x4)
Note: Vari-Lite recommends that this assembly be replaced as a complete assembly. Although you can replace only the motor, the pulley (Item 2) is bonded
to the motor shaft during assembly and cannot be removed intact. If you order a replacement motor (Item 4), also order the pulley (Item 2). Contact Vari-Lite
Customer Service for installation information.
116
L S
POT UMINAIRE ERVICE
12
3
15
4
1
7
Figure 3-30: Tilt Motor Assembly
M
ANUAL
Detail A
(x2)
(x6)
(x2)
(x2)
10 (x2)
13 (x2)
* As required to set proper height.
Pulley Height Detail & Installation
Step 1. Apply one drop of Loctite 603 to motor shaft.
Step 2. Install drive pulley on motor shaft using twisting
motion to insure coverage of shaft with loctite.
Step 3. Do not allow Loctite to drip into motor bearing.
Step 4. Set pulley height as shown above.
Step 5. Apply Loctite 242 to pulley set screws. Insure set
screws are aligned and tightened on flat sides of
motor shaft.
5b
5c (x2)
5a
Pressure-Sensitive Adhesive
0.239"
02 .9 698.00 10 0