DynaGen GSC400 Programmer's Manual
  1. Manuals
  2. Brands
  3. DynaGen Manuals
  4. Controller
  5. GSC400 Series
  6. Programmer's manual

DynaGen GSC400 Programmer's Manual

For generator
Hide thumbs Also See for GSC400:
1
2
3
4

Advertisement

Table of Contents

See also: Installer and User Manual
GSC400 Programmer Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GSC400 and is the answer not in the manual?

Questions and answers

Related Manuals for DynaGen GSC400

Summary of Contents for DynaGen GSC400

  • Page 1 GSC400 Programmer Manual...
  • Page 2 The USB and serial cables are used to connect the GSC400 programmer to the computer. Both are provided as a convenience and only one should be connected to the board. The 10 pin ribbon cable plugs into the programming port, red stripe facing the push button. The...
  • Page 3 Installing the USB Serial Port Driver (Vista, Windows XP, 2000). To use a USB cable to connect to the GSC400 programmer you must install the USB serial driver. This will allow you to communicate over USB by selecting a serial port. If you are using a serial cable you can skip this section.
  • Page 4 5. Click “OK” button on the “USB Serial Port settings” Then close the “Device Manager” window. 6. You will now be able to use the comm. port you selected to communicate to the GSC400 Programmer via USB. Setting up the Programmer to Update Settings.

Table of Contents