Volvo SENSUS NAVIGATION Manual page 23

1. In the navigation system's normal view, press
the thumb wheel/OK/MENU and select
Set destination Latitude and
2. Begin by deciding which type of GPS coordi-
nates are to be used by selecting
•
DD°MM'SS''
: location in degrees,
minutes and seconds.
•
Decimal
: location expressed in decimals.
3. Enter the GPS coordinates.
For additional information about the destina-
tion, select Information followed by the type
of information desired.
4. To store an address in the system's memory,
Save Stored location
select followed by
Home .
5. Set the address as an intermediate destina-
tion or a single destination:
•
Add as waypoint : adds the address as
an intermediate destination (waypoint) to
the itinerary.
•
Set single destination : deletes any pre-
vious destinations in an itinerary and
starts guidance to the selected destina-
tion.
Setting a destination using a position
on the map
longitude.
Format:
The cursor's position given in GPS coordinates. To dis-
play the name, select Settings
Position information.
1. In the navigation system's normal view, press
or
the thumb wheel/OK/MENU and select
Set destination
2. Move the cursor to the desired position, see
also Menus(p. 11) .
3. To store the position in the system's memory,
press the thumb wheel/OK/MENU and
select Save
Home .
> the destination will be stored as a sym-
bol/icon on the map if the function
Stored location on map
also Map alternatives (p. 29).
Map options
Select point on map.
followed by Stored location or
is selected, see
SETTING A DESTINATION, ITINERARY AND ROUTE
4. Set the address as an intermediate destina-
tion or a single destination:
•
Add as waypoint
: adds the address as
an intermediate destination (waypoint) to
the itinerary.
•
Set single destination
vious destinations in an itinerary and
starts guidance to the selected destina-
tion.
Setting a destination using the travel
guide
Searching using travel guide (not available in all
areas) offers suggested destinations/routes
according to various themes such as restaurants,
scenic drives, sight-seeing, etc.
A travel guide is stored on a USB flash drive that
has to be plugged into the vehicle's USB socket
in the tunnel console storage compartment.
1. In the navigation system's normal view, press
the thumb wheel/OK/MENU and select
Set destination Travel
If this menu alternative is not displayed, this
is because there are no suggestions for your
current location or no USB flash drive is con-
nected.
: deletes any pre-
guide.
}}
21