Attaching The Bass Boost Remote Control; Example Of Installation On The Floor Mat Or On The Chassis; Replacing The Top Cover - Pioneer PREMIER PRS-D1200M Owner's Manual

Installation
Attaching the bass boost remote
control
Attach with tapping screws (3 mm × 10 mm) at an
easily accessible location such as under the dash-
board.
15
Tapping screw
(3 mm × 10 mm)
Example of installation on the floor
mat or on the chassis
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 mm × 30 mm) into
the screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
2. Drill 2.5 mm (1/8 inch) diameter
holes at the point marked, and
install the amplifier, either on the
carpet or directly to the chassis.

Replacing the top cover

1. Align the unit and top cover, and
insert the screw.
• The cover can be installed in the desired
direction to match to the amplifier.
2. Tighten the screw with a 4 mm
hexagonal wrench.
Screw Top Cover
Drill a 2.5 mm (1/8 inch)
diameter hole
Tapping-screws
(4 mm × 30 mm)
Floor mat
or chassis