Pioneer PREMIER PRS-D1200M Owner's Manual page 13

Four Amplifier (Ex. Bridge)
MODE SELECT switch
must be in MASTER position.
2 Ω to 16 Ω
MODE SELECT switch must be
in SYNC INV position.
• Only use speakers having an impedance of 2 Ω to 16 Ω. In addition, in the case of connecting multiple
speakers with a bridge, check that the synthetic impedance is at least 2 Ω.
• The setting of the POWER MODE switch varies according to the speaker impedance. Slide the POWER
MODE switch to the HI-CURRENT position if the impedance is from 2 Ω to less than 4 Ω, or slide it to the
NORMAL position if the impedance is from 4 Ω to 16 Ω. The same setting is used for four amplifiers.
• When switching to the SYNC INV mode, the stopper over the MODE SELECT switch must be removed
and you can find SYNC INV switch. Remove the stopper after checking that connections are correct.
Connecting speaker wire (sold separately). Connecting speaker wire (sold separately).
MODE SELECT switch must be
in SYNC INV position.
MODE SELECT switch must be
in SYNC INV position.
Connecting speaker wire (sold separately). Connecting speaker wire (sold separately).
Connect to a car stereo.
For details, see the
SYNC OUT
"Connection Diagram".
Connecting wire with RCA
pin plugs (sold separately).
SYNC OUT
Connecting wire with
SYNC IN
RCA pin plugs (sold
separately).
SYNC IN
SYNC OUT
Connecting wire with RCA
pin plugs (sold separately).
SYNC IN
12