SAGEMCOM D16V User Manual page 25

D16V/D18V/D21V
11.7.
15.2.2. Telephone
11.7.1. Deleting the current message
Problem
During the pNo dial tone layback of the message, press the
The message in progress is deleted: - Is the base power cord connected to a
- If you have other messages, the next message working outlet? is broadcast.
- Otherwise, the answering machine returns to standby mode. - Is the telephone line cord
connected to the base unit and the wall jack?
11.7.2. Deleting all messages already played back
connect another phone to the same jack. If 1. In standby mode, hold down the
hear a beep.
This beep informs you that all your messages already played back have been deleted.
x
- OR -
answ machine "using the
1. Press . Select "
Select "delete all" using the or key, press
2.
Did the IN USE indicator come on?
3. Press to confirm deletion.
A beep indicates that all messages already played The battery may need to be charged. back
have been deleted.
Dial tone is OK, but can't dial out
12.
Handset does not ring
12.1.
Number of rings
This parameter enables you to set the number
before the ny extension phones on your line. Try unplugging some phones. answering machine
answers a call. The number of rings can be set between 2 and 7.
You can also select the "ECONOMY"mode. The "ECONOMy
«NO dial tone».
automatically
number of rings: If there are You experience static, noise no new messages on the or fading in
x
Is handset out of range? answering machine, the number of rings will be 4, otherwise the
number of rings will be 2. Move closer to the base. and out
relocated?
Press . Select "answ machine " using the
1.
2. Select "settings" using the or key, press with another household appliance. .
Select "ring delay" using the or key, press
3.
English
Deleting messages
Solution
x
Is the handset out of range of the base?
x
Make sure the batt or key, press ery is pr.
(12 hours).
x
x
Make sure the tone/pulse setting is correct.
Answering machine setup
RINGER setting on the
handset is programmed to ON.
x
determines the
x
- 25
x
Check installation: key.
Disconnect the base from the wall jack and
there is no dial tone in the second phone, the
problem might be your wiring or local service.
Is the battery pack installed correctly? .
of times your teYou may have too malephone rings
x
See solutions
x
Does the base need to be
x
Charge battery.
or key, press .
Make sure base is not plugged into an outlet
.
key until you
operly charged
x
Make sure the
for
" mode
x