Sagem F@st 1201 Reference Manual page 79

Field
Standard Mode
Blocking Mode
Disable DHCP
Enable DHCP
Start IP Address
End IP Address
Lease Time (hour)
Configure the second IP
Address and Subnet
Mask for LAN interface
IP Address
Subnet Mask
9
This field only appears when the "Enable DHCP" field is activated (box checked).
10
This field only appears when the "Configure the second IP Address and Subnet Mask for LAN interface" field is
activated (box checked).
Sagem Communications document. Reproduction and disclosure prohibited
Check the box if you wish the IGMP snooping
runs in normal mode (transparency with
IGMP frames).
Check the box if you wish the IGMP snooping
runs in blocking mode (interception and
removal of IGMP frames).
Check the box to not activate your router's
DHCP server.
Note: You must configure your computer
with the parameters appropriate to
your local network (IP address,
subnet mask and default gateway) as
well as enter the primary and
secondary DNS server addresses.
Check the box to activate your router's DHCP
server.
Note: You must configure your computer as
DHCP client and DNS client (or
enter the primary and secondary
DNS server addresses).
Enter the first address attributed by your
router's DHCP server.
9
Enter the last address attributed by your
router's DHCP server.
9
Enter an unavailability time for each address
attributed expressed in hours.
Check the box to configure the IP parameters
(IP address, subnet mask) of a second
address for the local network (LAN).
10
Enter a second address for your local
network (LAN).
10
Enter a subnet mask for the second address
for your local network (LAN).
SAGEM F@st™ 1201/1241 V2 Reference Manual - 253151640-A
5 - Information / Configuration
Action Default
Box checked
Box
not checked
Box
not checked
Box checked
192.168.1.2
192.168.1.254
24
Box not
checked
_
_
Page 5-45