Checking The Connections - Malaguti CNK 50 DRAKON Workshop Manual

IDENTIFICATION OF ELECTRICAL
B
4

CHECKING THE CONNECTIONS

Check rust and moisture of connectors.
1) Disconnect
• Connectors
2) Dry each terminal with an air blower.
3) Connect and disconnect the connector twice or three
times.
4) Pull the connector to check that it will not come off.
5) If the terminal comes off, bend up pin (A) and reinsert
the terminal into the connector.
6) Connect
• Connectors
NOTE
The connector parts are assembled properly when they
"click" together.
7) Check for continuity with a Tester.
NOTE
• If there is no continuity, clean the terminals.
• Be sure to perform the steps 1 to 7 when checking the
electrical system.
• For a field remedy, use a contact revitalizer.
• Use the Tester as shown in figure.
SYSTEM FAILURES
8
4 - CHECKING THE CONNECTIONS
05188013
05188014
05188015
05188016
03/06
DRAKON 50 NKD
A