Remove Programs - Honeywell Dolphin 9900 User Manual

Remove Programs

The Remove Programs settings enables you to remove programs installed on the terminal. Use this
setting to troubleshoot when you receive messages that the device is low on of memory.
The programs removed here are removed from RAM memory. Any program (usually *.cab or *.dll files)
stored in the Autoinstall folder (My Device > IPSM > AutoInstall) will re-install after the next hard reset;
see Hard Reset (Cold Boot) on page 3-20.
1. Tap the Remove Programs icon.
2. In the list, select a program and tap Remove. The following message appears:
3. Tap Yes. Wait while the program is removed.
4. Verify that the program no longer appears in the list.
6 - 12 Rev (a) 02 Dolphin® 9900 Mobile Computer
3/5/08
User's Guide–Preliminary