Remove Programs - Honeywell Dolphin 99EX User Manual

Preliminary Draft 1/19/11

Remove Programs

Remove Programs enables you to remove programs installed on the terminal. Use this setting to trouble-
shoot when you receive messages that the terminal is out of memory. The programs removed are
removed from RAM memory. Any program (usually CAB or DLL files) stored in the Autoinstall folder (My
Device > IPSM > Honeywell > Autoinstall) will re-install after the next hard reset, operating system
upgrade or a factory reset.
For information about the hard reset process, see Hard Reset (Cold Boot) on page 3-17. See Honeywell
support for more information on how to perform a factory reset.
1. Tap Remove Programs. In the list, select the program you want to remove.
2. Tap Remove. The following message appears:
3. Tap Yes. Wait while the program is removed.
4. Verify that the program no longer appears in the list.
7 - 17