Honeywell Dolphin 9900 User Manual page 15

2. The terminal initializes and the splash screen displays for a few seconds. The Build numbers
indicate the software version.
3. The system performs a hard reset. When the display activates again, follow the instructions that
appear.
Step 5. Align the Screen
You are prompted to align the screen by tapping the target five times. Use the stylus provided by
Honeywell.
• Alignment should always be performed with a stylus designed for touch panel applications. The small
point is required for accurate calibration.
• Press the stylus firmly into the center of the cross-hair target once and release. Do not "double-tap" the
target.
• You can re-align the screen at any time by going to Start > Settings > System tab > Screen.
Step 6. Let Autoinstall Run
For each program that loads, a status bar indicates that the program is loading. Autoinstall occurs after
each hard reset. Do NOT touch the keyboard or the screen while programs are loading. All configurations
of the Dolphin terminal install Demos and Power Tools. If the terminal is configured with a wireless radio,
the appropriate radio drivers and utilities for each radio install.
After Autoinstall is complete, the terminal performs a soft reset automatically. When it finishes booting up
after the soft reset, the Today screen appears; see
Step 7. Set the Time and Date
You need to re-set the time and date after every hard reset of the terminal. It is a good idea to set the time
and date now before you begin using the device.
Dolphin® 9900 Mobile Computer User's
Guide–Preliminary
Bootloader
Kernel
9.XX/9.XX/9.XX/9.XX
Rev (a) 02
3/5/08
Keyboard
Initial
Program
Loader (IPL)
Today Screen on page 4-2.
2 - 3