Important Safety Instructions; Tools Required For Assembly - Da-Lite IDEA Instruction Book

Disclaimer
Milestone and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete.
However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide
for every possible contingency in connection with the installation or use of this subject to change without notice or obligation of any
kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein. Milestone
assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Da-Lite® is a registered trademark of Milestone AV Technologies. All rights reserved.

Important Safety Instructions

1. Read and understand all instructions before using.
2. Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the structure to which this component is attached can support the weight of all equipment. Reinforce
the structure as required before installing the component.
3. Use this projection screen only for its intended use as described in these instructions. Do not use attachments not recommended by the
manufacturer.

Tools Required For Assembly

Phillips Screwdriver
Hardware Provided - Touch Module Bracket
(2) #4 x 1/2" Screws (2) #4 Nuts
2
Save These Instructions
Rubber Mallet
(2) #8 x 1/2" Screws
Level Measuring Tape
(1) Bracket
⅜" Open Wrench
or Socket Driver
(IDEA Panoramic)
1/4" Wrench