STEP 2: (SEE FIGURE 2 AND 1)
•
Slide the axle through the two axle brackets.
•
Assemble a spacer (R), a spacer (Q), a 3/4" washer
(H), a wheel (valve stem facing out) and another 3/4"
washer (H) onto the axle. Assemble a cotter pin (M)
through the end of the axle. Repeat on other end.
•
Tighten the four nuts which fasten the axle clamps to
the frame tubes. Refer back to figure 1.
1/8" x 1-1/2"
COTTER PIN (M)
SPACER (R)
SPACER (Q)
FIGURE 2
3/4" WASHER (H)
STEP 4: (SEE FIGURE 4)
•
Fasten the ends of the hitch arms together using two
5/16" x 1-1/4" hex bolts (B) and 5/16" nylock nuts (F).
Do not tighten yet.
•
Assemble the hitch brackets to the hitch arms using
two 5/16" x 2" hex bolts (A) and 5/16" nylock nuts
(F). Position each bolt behind a cross bolt in the hitch
arms. Do not tighten yet.
•
Tighten all nuts assembled in steps 3 and 4 at this
time.
5116" x 2"
REX BOLT (A)
5116"NYLOCK
NUT (F)
!
FIGURE 4
STEP 3: (SEE FIGURE 3)
•
Assemble a hitch arm to the inside of a frame tube
underneath the tank. Use two 5/16" x 2" hex bolts
(A) and 5/16" nylock nuts (F). Do not tighten yet.
Repeat for other side.
FIGURE 3
NYLOCK
NUT (F)
511 6" x 2"
REX BOLT(A)
\
HITCH ARM
STEP 5: (SEE FIGURE 5)
•
Assemble the boom mount bracket to the rear of the
frame tubes using two 5/16" x 2" hex bolts (A) and
5/16" nylock nuts (F).
FIGURE 5
5116" x 2"
HEX BOLT (A)
f
J
5/16" NYLOCK NUT (F)
REAR ViEW