Advertisement
....
I
N
0)
Mol'\itor-to-Monitor Data Co~y -
COPV Manu
When multiple monitors are connected via their serial
remote ports, data can be shared between the monitors
by data copy.
The
data copy from one monitor to
another is accomplished with the COPY menu.
This section explains the setting lists displayed in the
menu.
The lists are numbered and shown with indentations to
indicate the hierarchy in the menu.
If
a setting in each list leads to another list or a
monitor operation. the list number or the operation is
indicated after the
~
mark. (Settings without the
~
mark end in a single list.)
Select COPY from the menu list.
CONTROL PRESET ADJ ...
COLOR TEMP ADJ ...
SETUP ...
MEMORY CARD ...
STATUS ...
MAINTENANCE ...
KEY PROTECT
Menu list
OFF
850
COPY menu: Select the copy source monitor.
MONITOR ADDRESS: Enter the address number.
~
851
851
COPY: Select the data to
be
copied.
~
Copy Is carried out.
ALL: Copy data for all menu settings.
CONTROL PRESET: Copy the data for the CONTROL PRESET ADJ menu settings.
COLOR TEMP: Copy the data for the COLOR TEMP menu settings.
SET UP: Copy the data for the SET UP menu settings.
Displaying Information About the Monitor -
STATUS Menu
The STATUS menu is used to view general data about
the monitor and information about signals assigned to
the slots in the rear panel.
--·--.~~iij<i;ij~f•"•ii~i'•riif•
This section explains the setting lists displayed in the
menu.
The lists are numbered and shown with indentations to
indicate the hierarchy in the menu.
If a setting in each list leads to another list or a
monitor operation. the list number or the operation is
indicated after the~
mark. (Settings without the~
mark end in a single list.)
Select STATUS from the menu list.
CONTROL PRESET ADJ ...
COLOR TEMP ADJ ...
SETUP ...
MEMORY CARD ...
COPY ...
MAINTENANCE ...
KEY PROTECT
OFF
Menu list
900
STATUS menu (1/3): Data about the current channel is displayed.
CH:
channel number
SL: slot number
IN: input connector number
FORMAT: format of the input signal
NAME: channel name
900
STATUS menu (2/3): Data about the monitor is displayed.
MODEL NAME: model name
SERIAL NO: serial number
OPERATION TIME: operation time (in hours)
SOFTWARE VERSION: software version
Advertisement
