Advertisement
_.
.
_.
co
Assigning the Remote Control Functions -
A~MOTJ;: Mt='nu
The remote control functions are set with the
REMOTE menu. With this monitor, both serial
remote control (REMOTE I) and parallel remote
control (REMOTE 2) are possible. It is
possible to simultaneously use the
BKM-IOR,
REMOTE I, and REMOTE 2 for control, but
commands from REMOTE 2 have priority. Therefore,
it is impossible for the
BKM-IOR
or REMOTE I lo
change items set by REMOTE 2.
There is no priority order between commands from
REMOTE I and the
BKM-IOR;
it is possible to set
APERTURE to ON from REMOTE I and then set it to
OFF with a control panel operation.
About Monitor Address and Group
Numbers
The monitor control unit BKM-IOR or the integrated
control unit monitors BVM-14E5E/14E5U/14F5E/
14F5U are able to control up to 32 monitors connected
via serial remote connector (using the REMOTE I
connector). By giving each monitor a monitor address
and group number, it is possible to control just a
specific monitor or monitor group.
With the REMOTE menu, each monitor can be set
with a monitor address and group number, between I
and 99. The ADDRESS menu is used to select a
particular monitor or group by entering a monitor
number or group number.
For information about the ADDRESS menu, see "Selec·ting
the Monitor to Control -ADDRESS Menu" .
·· .. ··•-·~~,--~~·~•~1.,e:
... u
This section explains the setting lists displayed in the
menu.
The lists are numbered and shown with indentations to
indicate the hierarchy in
the
menu.
If a setting in each list 1eads to another list or a
monitor operation, the 1ist number or the operation is
indicated after the~
mark. (Settings without the~
mark end in a single list.)
Select SET UP from the menu list.
CONTROL PRESET ADJ ...
COLOR TEMP ADJ ...
MEMORY CARD ...
COPY ...
STATUS ...
MAINTENANCE ...
KEY PROTECT
OFF
Menu list
300
SET UP menu list: Choose the menu for setting the desired items.
INPUT CONFIGURATION
menu
PASSWORD menu
SYSTEM CONFIGURATION
menu
ON SCREEN SET menu
ALIGNMENT
menu
340
REMOTE menu: Select the type of remote control.
PARA REMOTE: Select whether or not parallel remote control will be used (ON or OFF).
PARA REMOTE CONFIG ... : Set the pin assignments for the REMOTE2 (parallel remote control)
connector.~
341
SERI REMOTE CONFIG ... : Set the address and group number of the monitor controlled via the
REMOTE I (serial remote control) connector.
~
343
Advertisement
