Advertisement
.....
I
N
0
Setting
the
Password
-
PASSWORD
Menu
400
PASSWORD menu: Enter the password for the PASSWORD menu.
ENTER PASSWORD: Enter the password (factory setting: 9999).
cc:>
401
401
PASSWORD:
Choose what action to perform with the password.
CHANGE PASSWORD ... : Change the password.
cc:>
402
APPLY PASSWORD ... : Assign the password to a menu item.
cc:>
404
402
ENTER NEW PASSWORD: Crate a new password.
J
ENTER NEW PASSWORD: Enter a password.
cc:>
403
403
CHANGE PASSWORD: Change the password.
RE-ENTER PASSWORD
TO CONFIRM
Enter the new password again and press the ENTER button.
cc:>
The password is
recorded.
To change it, press the MENU button.
cc:>
Return to the PASSWORD (401).
404
APPLY PASSWORD: Choose whether or not to apply the password to each menu .
CONTROL PRESET ADJ:
YES
or NO.
CONTROL TEMP ADJ:
YES
or NO.
SET UP:
YES
or NO.
MEMORY CARD: YES or NO.
Setting the Channel Selection Method and Power-
Up Conditions
-
SYSTEM
CONFIGURATION Menu
The SYSTEM CONFIGURATION menu is used for
the following settings:
(I)
Channel number entry method
The two ways in which the ten-key
pad
can be used to
enter channel numbers are as follows:
(In the explanation below, x and y represent any digit
between I and 9.)
DIRECT mode: When selecting a number from I to
9, press the x button to display channel x. When
selecting a number from 10 to 99, press the 0, x,
and y buttons to display channel xy (a two-digit
channel number). This mode is selected at the
shipping.
JOKEY mode: When the x button is pressed followed
by the ENTER button, the monitor displays channel
x. When the x buttons is pressed, followed by the y
and ENTER buttons, the monitor displays channel
xy (a two-digit channel number).
When multiple monitors are connected by a serial
remote connection, this setting will be common to all
the monitors.
It
is not possible to change the setting
for individual monitors.
(2) Power-up condition
This menu sets the condition of the monitor when the
main power switch on the rear panel is switched on.
ON: Standby mode
OFF: Operation mode
(3)
Power-up Input channel
LAST: Set the channel to the channel that was
selected at the time the power was last turned off.
CH
xx:
Set the channel to a specific channel number.
(4) Time from power-up until degauss
If
several monitors are turned on at the same time and
all start degaussing at the same time, there will be a
very large current draw on the power supply for a few
moments. To prevent this, the delay time between
power-up and degaussing can be set for each monitor
independently.
(S)AFC time constant
(6)Resldual subcarrler detection (when using the
BKM-24N/25P)
It
is possible to detect residual subcarrier signals from
phase change by setting the adaptor' s residual
subcarrier switch on.
(7)Auto chroma control (ACC) (when using the
BKM-27T)
Advertisement
