Battery States; External Battery Charger - Honeywell AreaRAE Plus User Manual

AreaRAE Plus & AreaRAE Pro User's Guide
Charging without a VOC sensor installed: After the battery is fully charged, the green LEDs flash once
every 10 seconds.
Charging with a VOC sensor installed: The AreaRAEPro performs a VOC sensor auto-cleaning for
two hours, and then it runs the pump for 20 minutes. The large battery icon is shown on the screen while
auto cleaning is taking place. After auto cleaning is completed and the battery is fully charged, the green
LEDs flash once every 10 seconds.
Note: The AreaRAE Plus/Pro does not charge alkaline batteries in the alkaline battery pack.
Always securely close the cover over the power port when not charging. This keeps moisture and debris
out of the port.

10.2 Battery States

The battery icon on the display shows how much charge is in the battery and alerts you to any charging
problems.
Full charge 2/3 charge 1/3 charge Low charge
When the battery's charge falls below a preset voltage, the instrument warns you by beeping
once and flashing once every minute, and the "empty battery" icon blinks on and off once per
second. The instrument automatically powers down within 15 minutes, after which you will
need to either recharge the battery, or replace it with a fresh one with a full charge.

10.3 External Battery Charger

You can charge a spare Li-Ion battery with the optional External Li-Ion Battery Charger For AreaRAE
(P/N: W01-3005-000).
Top View
Align the Charger's
edges and contact pins
with the battery
Rear View
IMPORTANT!
Press the Charger into
place, making sure the
contact pins mate
31
Battery
alert
Press down on the back
of the Charger to ensure
that it is securely set