Table of Contents
Advertisement
3.
Error Information and Measures in User Mode
The radio self-checks when power on. If no error is detected, the radio enters conventional mode. While the radio will
sound alert once any error is checked.
Error information and measures:
No.
Error Information
1
Stun status
2
Data and Firmware Version mismatch
4.
Firmware Version Display Mode
Turn the radio on while holding down [P4] to enter Firmware Version Display Mode, the firmware version will be displayed
on the LCD.
Release [P4] to enter User Mode.
5.
PC Programming Mode
Connect the radio with a PC by programming cable. If data is written to the radio from PC, it can be programmed into the
EEPROM. Data programming is accessible by programming software.
When data is written to the radio from PC, " PROGRAM"appears on the LCD. LED glows green when data is written to the
radio and red when data is read from the radio. Radio will restart automatically when programming is completed.
6.
Wired Clone Mode
Data can be transmitted from radio to radio by wired cloning.
(1)
Turn on the source radio while holding down [P3] simultaneously, the radio enters Clone Mode with " CLONE"on
the LCD, or enters User Mode if Clone Mode is disabled by your dealer.
(2)
Press [P3] to toggle between Dealer Clone and Factory Clone Mode. " DEACLONE"or " FACCLONE"appears on
the display when the corresponding mode is selected. The radio restores the original display after 5 seconds.
Unlike Factory Clone Mode, adjustment settings and embedded messages are not covered in Dealer Clone Mode.
Dealer Clone Mode is the default mode.
(3)
Connect the two radios by cloning cable, then turn on the target radio.
(4)
Press [P4] to start cloning, the LED of source radio glows red and that of target radio glows green during cloning.
" PROGRAM"is also displayed on the target radio. " END"appears on the source radio when cloning is completed
and the target radio enters user mode.
(5)
Press [P4] to return to Clone Mode. " CLONE"appears on the source radio. Repeat the above steps to continue
wired cloning.
Note: Cloning is available only when both radios are in the same mode.
7.
Panel Tuning Mode
The radio is tuned in this mode. Operations are as follows:
(1)
Press [P1] to turn on the radio and enter tuning mode.
LCD Display
Stun
Re-program.
Re-program with programming software of right
No Data
version.
8
TM-610 Service Manual
Measures
Hide quick links:
Advertisement
Table of Contents
