Removing The Module - Planet Networking & Communication MGSW-28240F User Manual

10Gbps SFP+ (10GBASE-BX, Single Fiber Bi-directional SFP)
Model Speed (Mbps)
MTB-LA20 10G
MTB-LB20
10G
MTB-LA40 10G
MTB-LB40
10G
MTB-LA60 10G
MTB-LB60
10G
1. It is recommended to use PLANET SFP/SFP+ on the Managed Switch. If you insert an
SFP/SFP+ transceiver that is not supported, the Managed Switch will not recognize it.
2. Please choose the SFP/SFP+ transceiver which can be operated under -40~75 degrees C
temperature if the switch device is working in a 0~50 degrees C temperature environment.
1. Before we connect the MGSW-MGSD series to the other network device, we have to make sure both sides of the SFP
transceivers are with the same media type, for example, 1000BASE-SX to 1000BASE-SX, 1000Bas-LX to 1000BASE-LX.
2. Check whether the fiber-optic cable type matches with the SFP transceiver requirement.
 To connect to 1000BASE-SX SFP transceiver, please use the multi-mode fiber cable with one side being the male
duplex LC connector type.
 To connect to 1000BASE-LX SFP transceiver, please use the single-mode fiber cable with one side being the male
duplex LC connector type.

Connect the Fiber Cable
1. Insert the duplex LC connector into the SFP/SFP+ transceiver.
2. Connect the other end of the cable to a device with SFP/SFP+ transceiver installed.
3. Check the LNK/ACT LED of the SFP/SFP+ slot on the front of the Managed Switch. Ensure that the SFP/SFP+
transceiver is operating correctly.
4. Check the Link mode of the SFP/SFP+ port if the link fails. To function with some fiber-NICs or Media Converters, user has
to set the port link mode to "10G Force", "1000M Force" or "100M Force".

2.3.2 Removing the Module

1. Make sure there is no network activity by checking with the network administrator, or through the management interface of
the switch/converter (if available) to disable the port in advance.
2. Remove the Fiber Optic Cable gently.
3. Lift up the lever of the MGB module and turn it to a horizontal position.
4. Pull out the module gently through the lever.
Connector
Fiber Mode
Interface
WDM(LC) Single Mode
WDM(LC) Single Mode
WDM(LC) Single Mode
WDM(LC) Single Mode
WDM(LC) Single Mode
WDM(LC) Single Mode
User's Manual of MGSW-MGSD Series
Distance Wavelength (TX) Wavelength (RX) Operating Temp.
20km 1270nm
20km 1330nm
40km 1270nm
40km 1330nm
60km 1270nm
60km 1330nm
39
1330nm 0 ~ 60 degrees C
1270nm 0 ~ 60 degrees C
1330nm 0 ~ 60 degrees C
1270nm 0 ~ 60 degrees C
1330nm 0 ~ 60 degrees C
1270nm 0 ~ 60 degrees C