Planet Networking & Communication MGSW-28240F User Manual page 136

The scenario described as follows:

Untagged packet entering VLAN 2
While [PC-1] transmit an untagged packet enters Port-1, the Managed Switch will tag it with a VLAN Tag=2.
1.
[PC-2] and [PC-3] will receive the packet through Port-2 and Port-3.
[PC-4],[PC-5] and [PC-6] received no packet.
2.
While the packet leaves Port-2, it will be stripped away it tag becoming an untagged packet.
3.
While the packet leaves Port-3, it will keep as a tagged packet with VLAN Tag=2.
4.

Tagged packet entering VLAN 2
While [PC-3] transmits a tagged packet with VLAN Tag=2 enters Port-3, [PC-1] and [PC-2] will receive the packet
5.
through Port-1 and Port-2.
While the packet leaves Port-1 and Port-2, it will be stripped away it tag becoming an untagged packet.
6.

Untagged packet entering VLAN 3
1. While [PC-4] transmits an untagged packet enters Port-4, the switch will tag it with a VLAN Tag=3. [PC-5] and
[PC-6] will receive the packet through Port-5 and Port-6.
2. While the packet leaves Port-5, it will be stripped away it tag becoming an untagged packet.
3. While the packet leaves Port-6, it will keep as a tagged packet with VLAN Tag=3.
For this example, VLAN Group 1 is set as default VLAN, but only focuses on VLAN 2 and VLAN 3
traffic flow. The example screenshot comes from the other switch but the configuration interface is the
same with MGSW-MGSD Series Managed Switch.
Setup steps
1. Create VLAN Group
Add two VLANs – VLAN 2 and VLAN 3
Type 1-3 in Allowed Access VLANs column, the 1-3 is including VLAN1 and 2 and 3.
2. Assign VLAN Member :
VLAN 2 : Port-1,Port-2 and Port-3
VLAN 3 : Port-4, Port-5 and Port-6
VLAN 1 : All other ports – Port-7~Port-28
Figure 4-6-9: Add VLAN 2 and VLAN 3
136
User's Manual of MGSW-MGSD Series