Mounting The Device On A Din Rail - Siemens RUGGEDCOM RS900W Installation Manual

Chapter 2
Installing the Device
Forced airflow is not required. However, any increase in airflow will result in a reduction of ambient
temperature and improve the long-term reliability of all equipment mounted in the rack space.
NOTE
For detailed dimensions of the device with either DIN rail or panel hardware installed, refer to
Chapter 5, Dimension
CONTENTS
• Section 2.5.1, "Mounting the Device on a DIN Rail"
• Section 2.5.2, "Mounting the Device to a Panel"
Section 2.5.1

Mounting the Device on a DIN Rail

For DIN rail installations, the RS900W can be equipped with a DIN rail bracket pre-installed on the back of the
chassis. The bracket allows the device to be slid onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1. Align the slot in the bracket with the DIN rail.
1
Figure 2: DIN Rail Mounting
1. DIN Rail 2. DIN Rail Bracket
2. Pull the release on the bracket down and slide the device onto the DIN rail. Let go of the release to lock the
device in position. If access to the release is limited, use a slotted screwdriver or a similar tool to reach the
release.
8
Drawings.
RUGGEDCOM RS900W
Installation Guide
1
2
Mounting the Device on a DIN Rail