Configuring The Device; Resetting The Device - Siemens RUGGEDCOM RS900W Installation Manual

Chapter 2
Installing the Device
Section 2.10

Configuring the Device

Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROS interface. For more information about configuring the device, refer to the
RUGGEDCOM ROS User Guide associated with the installed software release.
Section 2.11

Resetting the Device

The RUGGEDCOM RS900W can be reset (rebooted) using the RESET button. The RESET button is recessed and can
only be reached using a pin or small screwdriver.
To reset the device, quickly press and release the RESET button with a pin.
16
RUGGEDCOM RS900W
Installation Guide
Configuring the Device