Table of Contents
Advertisement
Project 52
House with Doorbell
Assembly:
1. Place parts on grid B, including the base grid support, 90 degree vertical
snap wires (V1), and press switch (S2). Note that grid B is the two-sided
grid, and the press switch is on the reverse side. Install grid B on grid A.
2. Place remaining parts on grid A.
3. Install grids C, D, & E into base grid supports on grid A, and secure with
4 stabilizers.
Push the press switch to ring the doorbell. It sounds best if you press it for
a few seconds.
-42-
Advertisement
Table of Contents
Need help?
Do you have a question about the SC3DMEG and is the answer not in the manual?