Flashforge FINDER Quick Start Manual page 8

Confirm
Are you sure you can't
tighten these three nuts any
more?
Yes
2. Tap [Yes] if you can't tighten all the nuts any more, or tap [No] to continue tightening.
After selecting [Yes], the extruder will move towards the first point and the plate will move up
and down to verify the distance between nozzle and plate.
Distance Too Big
Unscrew corresponding nut under
platform clockwise until hearing
a steady beep.
3. If the distance between the nozzle and plate is too large, rotate the knob underneath the
platform clockwise until you hear a steady beep. If the distance is too small, rotate the knob
anticlockwise until you hear a steady beep.
Please tap [Verify] button to
check whether the distance
is appropriate now.
4. Then tap the [Verify] button to check whether the distance is appropriate this time.
If the distance is appropriate now, tap [OK] to the second leveling point. If still not, please
follow the prompts to adjust again till you see [OK] button.
Repeat steps 3 and 4 to level the second and third points. Then tap [Finish] to exit.
No
Wait
Verify
Verifying the distance between nozzle
and plate...
Distance Too Small
Screw corresponding nut under
platform anticlockwise until
hearing a steady beep.
Congrats
Tap [OK] button
to next point leveling.
07
Wait
OK