Maintenance; Recommended Maintenance Schedule; Flywheel Opening And Cleaning; Warranty Information - Concept2 BikeERG Product Manual

Concept2 BikeErg

MAINTENANCE

Recommended Maintenance Schedule

Daily
• Clean saddle, handlebars, step pad and
flywheel with a cloth and cleaner after use.
• Do not use bleach or coarse abrasives.
Every 250 hours of use
• Verify that the crank arms are tight on the crank
axle. Tighten the clamp screw if needed using
the T27 driver supplied with the BikeErg.
• Check all screws and fasteners for tightness.
• Check for dust inside flywheel with a flashlight.
Vacuum if needed. See illustrations at right.
Verify calibration after cleaning. On the PM:
Main Menu>More Options>Utilities>Calibration
As Needed
Check the fit of the seat post. The seat post should
move up and down with only light pressure
applied. The seat post can be adjusted using a ½"
wrench (not included) where shown below. Do not
overtighten.

Warranty Information

Concept2 BikeErgs are backed by a limited 2 year and 5 year warranty. For complete warranty information in the US and
Canada, visit concept2.com/warranty.
For warranty information outside the US and Canada, contact the authorized Concept2 dealer in your territory. A list of
authorized Concept2 dealers can be found at concept2.com/international. If you do not find a local dealer in your territory visit
concept2.com or email rowing@concept2.com.
The safety level of the machine can be
WARNING!
maintained only if it is examined regularly for damage and wear.
Replace defective components immediately to ensure safety and
performance or keep machine out of use until repair.

Flywheel Opening and Cleaning

1.
Loosen screws.
3.
5.
7.
2.
4.
6.
5