Install Antenna Feeder System - Baicells mBS1100 Installation Manual

Hide thumbs Also See for mBS1100:

Table of Contents

Connect one end of the wire jumper to the RF port of the GPS antenna, fasten the

connector and connect the other end to the GPS antenna feeder lightning protector.

Then, connect one end of the other wire jumper to the GPS antenna feeder lightning

protector and the other end to the mBS1100 base station's GPS port.

Ground the antenna feeder lightning protector.

Note:

The GPS antenna feeder lightning protector must be grounded.

Waterproofing measures need to be taken on GPS connector, GPS antenna feeder

surge protective device connector, and the GPS antenna connector, using the

waterproof daub and waterproof tape, refer to 3.3.3.3 Waterproof Protection.

3.3.3 Install Antenna Feeder System

There are two kinds of outdoor antennas, omnidirectional outdoor antennas and

directional outdoor antennas, whose installation will be introduced in the following,

respectively.

Table of Contents